UralTone EuroRack series - power supply kit
As low as €69.00 €54.98
In stock
UralTone eurorack power supply uses 2x1250mA / 30W SMPS-module. The kit is separated in various parts to choose from: Front / brake out panel and the actual power supply board. It's possiple toi chain multiple supply boards for greater power output.
Power supply uses external 18-36V power brick. This improves the safety not having mains voltages on oftenpartially open Euro case.
Kit contains parts for ready power supply. It does not inlcude screws for rack mount, nor screws to mount the power supply board to enclosure.
In the core of the power supply is encapsulated 18-36V intake SMPS-module with voltage out trimmer and external control of output enable. Module has overload and short circuit protection. Enclosed maodule is easy to solder to boars with it's seven pins to solder. Operational frequency is 100kHz which pushes the possible interference out of autio spectrum. Distributed low voltage supply / power brick structure improves the electrical safety omitting the mains voltage out of the often partially open Euro rack.
On the PCB of the supply is some extras, such as pads for 7805 regulator for light load feed for +5V. The CV-Gate bus is divided to sections with jumper blocks. The CV-Gate bus is accessable with front panel kit.
The power supply may use as single unit. The PCB has pads for 2.1mm DC jack and pads to solder external power switch. If the rack need more power, it's possible to parallel connect more of the power supply boards with 4.8mm crimp connector cables. (Increasing the modules requires as well big enough of external mains adapter.)
The front panel kit contains DC-jack input, power switch, monitoring of the bus Voltages (+5V, +12V ja -12V) and needed cables to connect it to power supply board.
Finally theres few options for external mains adapter, 30W for single power supply board, 60W for dual config.
| SKU | 950-UT-EUROPOWER1250 |
|---|---|
| Barcode | 9900000294168 |
