Nitrocellulose lacquer 500ml spray, sunburst red (perfect for 3 tone transition)

Nitrocellulose Lacquer Spray 500ml, Sunburst Red Perfect for 3 Tone Transition

Nitrocellulose lacquer has been used on guitars since the fifties and sixties due to its excellent properties. By forming an extremely thin layer, it allows the wood to resonate freely. The lacquer surface can be easily patched and polished to a beautiful shine. Nitro lacquer ages (cracking, yellowing...) beautifully!

Use this aerosol only in well-ventilated, dry locations where the temperature is at least 15°C. Aerosols produce a lot of fine dust, remove or cover any objects that do not need lacquer. Always wear protective clothing/gloves/glasses! This must really be adhered to, as nitro lacquer is very dangerous if inhaled!

Shake the spray can very well (upside down) for a few minutes. Test the lacquer on a small piece of wood, metal, etc. Make sure that the area to be painted is clean, dust-free, grease-free, etc.
Hold the spray can vertically about 20 cm away from the area to be painted. Move the can slowly from side to side and start spraying, keeping the distance consistent. Change direction by releasing and pressing again. Apply a thin layer of lacquer and wait 10 minutes before spraying the next layer. The lacquer may take a few days to reach its final hardness.

After using the aerosol, hold the can upside down and spray until only gas comes out of the nozzle.